![edgecam training manual edgecam training manual](https://whatswrongwithedgecam.files.wordpress.com/2015/07/image5.jpg)
As the inventors of conversational, Hurco continually leads the industry in creating a user-friendly programming method that is intuitive and decreases setup time. Hurco is one of a handful of controls that lets you program a part for 5-sided machining without a CAM system. This is an important consideration when a shop is considers purchasing a 5-axis machining center to do 5-sided machining. Do you need a CAM system? For 5-sided machining, there are controls that allow machinists to program a 5-sided part without the need to buy a CAM system. Additionally, you need to make sure the control of your 3-axis VMC is 5-axis capable. The relatively small work surface means it should only be used for small parts (12 inches or less) and should not be used for heavy cutting operations. Because the tilting-rotary tables are quite large, they monopolize most of the 3-axis machining center’s work envelope.
![edgecam training manual edgecam training manual](https://s3.manualzz.com/store/data/032303773_1-dcab0f9315f09fdf3e219a7b66c09acd.png)
You can add a vise for greater versatility because of the large table size. Integrated trunnion table Swivel head with rotary table Traveling column Why / a swivel head with rotary table 5-axis machining center BC rotation axes configuration Heavier Parts: Because the table is stationary, the swivel head/rotary table machines are used with heavier parts. Machine Configurations Dedicated 5-axis machining centers There are three types of machine configurations for 5-axis machining.The axis that rotates about or under the Z-axis is called the C-axis. The axis that rotates about the Y-axis is called the B-axis. The axis that rotates about the X-axis is called the A-axis. With a 5-axis machining center, the additional rotary axes will rotate about two of those three primary axes. If you think in terms of a 3-axis machining center, it has an X-axis, Y-axis, and Z-axis.
![edgecam training manual edgecam training manual](https://getintopc.today/wp-content/uploads/2021/08/edgecam-2018-software.png)
5-sided (3+2) Simultaneous 5-axis (full 5-axis) Simple to program Cuts faster Fewer concerns about tool interference Excellent roughing strategy Better surface finish Longer tool life Allows tool to reach difficult places smoothly Impressive but slow – avoid if possible Basics of axis configuration To understand machine configurations, it’s important to understand the basic terminology of 5-axis machining centers. Simultaneous 5-axis There are pros and cons to both 5-sided machining and 5-axis machining.